Installing The Crank Handle - J&M 525 Setup Manual

Installing the Crank Handle

NOTE: If you are installing the optional Electric Roll Tarp go to top of the next page.
Slide tarp guide roller over rear end of 1-1/4" square roll tube . Then slide one washer over, then the spring return cable, then the next
washer . Now attach the knuckle to the roll pipe . Use (2) 3/8" x 2" hex bolts along with (2) 3/8" lock nuts . Attach the crank handle to the
universal joint . Install the crank handle using (1) 1/4" x 2-1/2" bolt and (1) 1/4" locknut . The universal joint may be pre-assembled to the
crank handle .
Check for proper function of the of the Roll Tarp .
Auger Side
Opposite Auger Side
14