Siren Default Settings; Siren Functions For Buttons 1-15 - Federal Signal Corporation SmartSiren Platinum Series Software Manual

Configuring the Siren

Siren Default Settings

Before you begin, you may want to review these siren default settings. For an keypad view of the default
settings, see the table in the appendix on page 115.
Button
Button 6
Button 7
Button 9
Button 10
Button 11
Button 12
Button 13
Slide Switch 1
Slide Switch 2
Slide Switch 3
Inputs 1 through 4
* The Button Control Module is not available because the option cannot be changed
Assigning Siren Functions to Buttons 1–15
The Siren Pane for Buttons 1–15 and the Horn Ring button has a variety of siren functions, including
eight siren tones, an electronic air horn, radio rebroadcast, and public address. Two functions for
activating siren tones are also available.
NOTE: The Standby siren function, which turns off all siren tones, except Air Horn and Manual, is
available with Buttons 1 and 6.
To assign a siren function to a button:
1. Click the a button in the range of 1 through 15.
2. Select how you want the button to operate by clicking an option
button in the Button Control pane. If you want the button to act as
a timer, select the duration from the drop-down list. Some buttons
have the Button Control option to be Exclusive. They turn on a
function when pressed and turn off the button that was pressed
previously in the same row.
60
Siren Function
Siren: Standby
Siren: Radio
Siren: Wail
Siren: Yelp
Siren: Priority
Siren: Manual
Siren: Air Horn
Horn Ring Transfer
Horn Ring Transfer
Siren Dependent Enabled
Horn Ring Transfer
SmartSiren Platinum Series
Button Control Activated Button
Exclusive
Exclusive
Exclusive
Exclusive
Exclusive
Momentary
Momentary
Momentary* Button 1
Momentary*
Momentary*
Momentary