Lightbar Default Settings; Assigning Lightbar Functions To Buttons - Federal Signal Corporation SmartSiren Platinum Series Software Manual

Configuring the Lightbar

Lightbar Default Settings

Before you begin, you may want to review these lightbar default settings. For an keypad view of the
default settings, see the table in the appendix on page 115.
Button
Slide Switch 1
Slide Switch 2
Slide Switch 3
Button 1
Button 2
Button 3
Button 4
Button 14
Button 15
* The Button Control Module is not available because the option cannot be changed.
Verify features before configuring the lightbar
Federal Signal lightbars may not have all the features available in the lightbar pane.
To make the software configuration of the control pad quick and accurate, determine
what hardware features and DIP switch settings are in the lightbar before you begin.

Assigning Lightbar Functions to Buttons

Buttons 1 to 5 and Buttons 14 and 15 can be programmed to activate when the operator puts the
slide switch into a position linked to one or more of these buttons. If you are configuring this feature,
first determine which buttons and functions to activate and their corresponding slide switch positions.
See "Linking Buttons to Slide Switch Positions (Lightbar Pane)" on page 39.
To assign lightbar functions:
1. Click any button except SignalMaster and Warn:
35
Button Control Pattern
Momentary* Lightbar Pattern 10
Momentary* Lightbar Pattern 17
Momentary* Lightbar Pattern 26
Push On/Off
Push On/Off
Push On/Off
Timer Intersection Pattern 22
Push On/Off
Push On/Off
Button Function Limits
The functions for all buttons (except Slide Switch 3, which accepts a limit of 20)
are limited to a maximum of 10.
SmartSiren Platinum Series
Auxiliary Function
Front Light Cutoff
Flash Takedown/Alley
Left Alley
Takedowns
Right Alley
Dimming
Rear Light Cutoff