Table of Contents
Advertisement
CHAPTER 2
Preparing to Program the Control Pad
PRECAUTIONS FOR CONFIGURING THE SMARTSIREN PLATINUM CONTROL PAD
Property damage, serious injury, or death may result if the SmartSiren Platinum control
pad is improperly configured. Configuration is to be performed at the time of the software
installation. It is NOT intended for operators to "customize" the operation of the control pad
for their individual preferences. It is the installer's responsibility to determine compatibility,
suitability, and ensure proper programming of the system. In addition, the person responsible
for programming MUST be familiar with local codes and procedures for the safe operation of
emergency-vehicle siren and lights.
System Requirements
The SmartSiren Platinum Configuration Software is supported on laptops and desktops meeting these
minimum requirements:
• 1 GHz Pentium
• Microsoft Windows
• 512 MB RAM for Windows XP
1 GB RAM for Windows Vista and Windows 7
Depending on your system, more memory may be required.
• 15 MB available disk space
• 1024 x 768-pixel monitor resolution, 16-bit display (32-bit recommended)
• CD-ROM drive
• One free RJ-45 Ethernet port for connection to the SmartSiren Platinum control pad with the included
Ethernet cable (Federal Signal part number 1751532)
This chapter explains how to install the SmartSiren Platinum Configuration Software on your computer.
It also explains how to establish an IP address between the control pad and your computer in
Windows XP, Windows Vista and Windows 7. A local area connection (LAN) is not needed because the
SmartSiren Platinum Configuration software creates a network between your computer and the control
pad. Finally, the chapter walks you through the process of setting up the control pad for programming.
To wire the control pad for 12 Vdc power, which is needed for programming, refer to the SmartSiren
Platinum Installation, Maintenance, and Service manual, document number 2562502 or the Quick
Connect Guide, document number 2562417.
10
3 processor or compatible (32-bit and 64-bit)
®
XP with Service Pack 2, Windows Vista or Windows 7 (32-bit and 64-bit versions)
®
SmartSiren Platinum Series
Advertisement
Table of Contents
Troubleshooting
