Table of Contents
Advertisement
Configuring the Siren
Assigning Siren Functions to Slide Switch 1–3
The control of siren tones, rather than the tones themselves, are selectable functions for the Slide
Switch. One option is Siren Dependent Enabled, which restricts siren activation to the slide switch
position you select. For example, if you press a button that is assigned a siren tone, the tone only
activates when you place the slide switch in the position that is Siren Dependent Enabled.
The Horn Ring Transfer option enables the driver to step through each Siren Function assigned to
the Horn Ring in the Button Configuration Module with each press of the horn button on the steering
wheel. Functions can include siren tones, such as Yelp and Wail, Radio rebroadcast through the siren
speakers, and Public Address, which transmits the operator's voice through the microphone to the
siren speakers.
To assign siren functions to a slide switch button:
1.
Click a Slide Switch button.
2.
If the Siren pane is not in front of the other Device Selection panes, click the Siren tab.
3.
Select Siren Dependent or Horn Ring Transfer or both.
63
Button Function Limits
The functions for all buttons (except Slide Switch 3, which accepts a limit of 20)
are limited to a maximum of 10.
Button Control for the Slide Switch
The Button Control Module is unavailable for the Slide Switch because each
switch position acts as a momentary button.
SmartSiren Platinum Series
Advertisement
Table of Contents
Troubleshooting
