Assigning Signalmaster Control To The Signalmaster Button - Federal Signal Corporation SmartSiren Platinum Series Software Manual

Control pad configuration

Table of Contents

Configuring the SignalMaster

Verify features before configuring the lightbar

Federal Signal ILS lightbars may not have all the features available in the lightbar pane.

To make the software configuration of the control pad quick and accurate, determine

what hardware features and DIP switch settings are in the lightbar before you begin.

Refer to "Setting Configuration Options" for the Rear ILS lightbar in Doc. No. 2562422

and "Setting Configuration Options" for the Front ILS lightbar in Doc. No. 2562423.

Assigning SignalMaster Control to the SignalMaster Button

When you click the SignalMaster button, a SignalMaster pane with default step-through SAE directional

patterns appears in the Device Selection Module. Select up to four networked SignalMaster types and

the application takes care of assigning the directional patterns for you, in which each press of the button

steps through a selection of Left, Right, Center Out.

To assign SignalMaster control to the SignalMaster button.

Click the SignalMaster button. The SignalMaster pane moves to the front.

SmartSiren Platinum Series

Table of Contents