Uploading The Configuration File To The Control Pad; Putting The Control Pad Into Operation Mode - Federal Signal Corporation SmartSiren Platinum Series Software Manual

Completing the Control Pad Configuration

Uploading the Configuration File to the Control Pad

Uploading the configuration file stores the file in the flash memory of the control pad.
To upload a configuration file:
1. In the System menu select Program Control Head.
2. Wait until the progress bar fills from left to right. When the upload is complete, the file is stored in
the flash memory of the control pad.

Putting the Control Pad into Operation Mode

For the SmartSiren Platinum system to follow the instructions in the configuration file, the control pad
must be put into Operation Mode.
1. Press Button 13. The first LED blinks and the control pad beeps to indicate you are in
Programming Mode.
2. Remove 12 Vdc power from the control pad, then reapply it. The control pad is in Operation Mode
and ready to control the SmartSiren Platinum system.
101
13
SmartSiren Platinum Series