Siren Control (Inputs 1-4); Siren Control (Slide Switch 1-3) - Federal Signal Corporation SmartSiren Platinum Series Software Manual

Configuring the Siren
Function
Siren Dependent Enabled
Horn Ring Transfer
Function
Siren Mute
70
Siren Control: Slide Switch 1–3
Description
Restricts siren activation to the slide switch position you
select. For example, if you press a button that is assigned
a siren tone, the tone only activates when you place the
slide switch in the position that is Siren Dependent
Enabled.
Available when the horn detection circuit is connected
either to pin 2 and pin 8 on the 12-pin connector on the
rear of the SmartSiren Platinum Siren Amplifier or to pin
10 on the back of the control pad.
The default setting for the slide switch is to transfer the
horn ring activation of the siren in Slide Switch 2 and 3.
Each press of the horn button on the steering wheel cycles
through the Siren Function selected for the Horn Ring
button. In addition, Slide Switch 2 is configured as Siren
Dependent Enabled.
Siren Control (Inputs 1–4)
Description
When selected for an Input circuit, this function deactivates
the all siren functions, except Air Horn and Manual, when
the circuit is active.
1 AND 2
GROUND ACTIVE
(ACTIVE LOW)
−GND
SmartSiren Platinum Series
3 AND 4
+12 V ACTIVE
(ACTIVE HIGH)
+12 V