Table of Contents
Advertisement
Configuring the ILS System
Verify features before configuring the lightbar
Federal Signal ILS lightbars may not have all the features available in the lightbar pane.
To make the software configuration of the control pad quick and accurate, determine
what hardware features and DIP switch settings are in the lightbar before you begin.
Refer to "Setting Configuration Options" for the Rear ILS lightbar in Doc. No. 2562422
and "Setting Configuration Options" for the Front ILS lightbar in Doc. No. 2562423.
Configuring the ILS System
There are no default settings for the ILS System.
To assign an ILS System function to a button:
1.
Click a button in the Button Configuration Module.
2.
Select how you want the button to operate by clicking an option button in the Button Control
pane. If you want the button to act as a timer, select the duration from the drop-down list.
Buttons 1–13 have the additional Button Control option to be Exclusive. They turn on a
function when pressed and turn off the button that was pressed previously in the same row.
90
Button Function Limits
The functions for all buttons (except Slide Switch 3, which accepts a limit of 20)
are limited to a maximum of 10.
SmartSiren Platinum Series
Advertisement
Table of Contents
Troubleshooting
