Table of Contents
Advertisement
CHAPTER 7
Configuring the Internal Relays
An Overview of the Internal Relays
The internal solid state relays in the Relay Pane connect to pins on the back of the SmartSiren Platinum
Siren Amplifier (page 79). The ten 10-ampere relays can be configured as active high (pulled to 12 Vdc
battery voltage) or active low (pulled to ground). The four three-ampere relays are active high only.
The internal relays are commonly used for non-serial controlled devices or small flashing lights.
Pane for all other buttons
Pane for SignalMaster button
SmartSiren Platinum Series
71
Advertisement
Table of Contents
Troubleshooting
