Assigning Signalmaster Control To The Warn Button - Federal Signal Corporation SmartSiren Platinum Series Software Manual

Control pad configuration

Table of Contents

Configuring the SignalMaster

Assigning SignalMaster Control to the Warn Button

When you select the Warn button, a SignalMaster pane appears in the Device Selection Module with

four step functions, each with 14 selectable warning patterns. SAE directional warn patterns are Warn

Patterns 1 through 4. Non-SAE Emergency Warn Patterns are Warn Patterns 5 through 14.

Buttons 1 to 5 and Buttons 14 and 15 can be programmed to activate when the operator puts the

slide switch into a position linked to one or more of these buttons. This feature enables the operator to

turn selected directional patterns on and off or skip steps in selecting a step-through SignalMaster warn

or directional pattern without changing the position of the slide switch. See "Assigning SignalMaster

Control to the Slide Switch" on page 54.

To assign a Signalmaster function to the Warn button:

Click the Warn button. The SignalMaster pane moves to the front.

Pop-Up Message: "Overwriting the Default Configuration"

When you select Save for the first time, the message "Trying to overwrite

protected default configuration" appears. Click OK. In the Save As dialog

box, navigate to the folder you created for your configuration files and save

the file under a new name. When you click Save again before closing the

application, it updates your renamed file by overwriting it.

SmartSiren Platinum Series

Table of Contents