Table of Contents
Advertisement
Exploring the Interface
If the control head firmware is incompatible with the version of the configuration software that you are
using, an error message appears.
For customer support, please call:
Service Department
Federal Signal Corporation
Phone: 1-800-433-9132
Fax: 1-800-343-9706
Email: empserviceinfo@fedsig.com
7 a.m. to 5 p.m., Monday through Friday (CT)
The Four Programming Modules
The SmartSiren Platinum is contained within an integrated workspace, which means each programming
module is displayed within a larger window. The four programming modules are: the Button
Configuration Module, the Button Selection Module, the Device Selection Module, and the
Button Control Module. The default configurations are listed in the chapters for each Device
Assignment Pane. In addition, the appendix has a table on page 116 of the default configurations for
every button.
The Button Configuration Module
The Button Configuration Module displays all devices
available in the Convergence Network, It also displays
functions assigned to the devices that are controlled the
button shown in the header. The Button Configuration
Module also displays device assignments for the four Input
circuits and the Horn Ring Transfer circuit as well.
The information is arranged in a directory tree. To expand
information about a device, click the plus sign (+) next to it.
To collapse the category, click the negative sign (–).
If the tree extends beyond the bottom of the module, a scroll
bar appears to the right. Click and hold the bar, then drag it
up and down to see the entire tree.
The illustration on the right displays the default settings for
Button 8. The button is configured to act as a Push On/
Off switch. When the button is pressed, the perimeter lights
connected to Relay 8 stay on without flashing (Steady On).
The circuit is supplying +12 Vdc during its "on" state (Active
High) and is open during its "off" state (Open Off).
24
SmartSiren Platinum Series
Advertisement
Table of Contents
Troubleshooting
