Chapter 5 Monitor; Explanation Of Monitor Signals; Name And Description Of The Monitor Signals - Mitsubishi Electric MR-J5 Series User Manual

5
MONITOR
Outline [G] [WG]
The status of servo motor speed, torque, bus voltage, and others of the servo amplifier can be checked with the engineering
tools and analog monitor. This chapter shows an example when using MR Configurator2 as the engineering tool.
Refer to the following manual for the method of using the object dictionary.
MR-J5 User's Manual (Communication Function)
Outline [A]
The status of servo motor speed, torque, bus voltage, and others of the servo amplifier can be checked with the engineering
tools and analog monitor. This chapter shows an example when using MR Configurator2 as the engineering tool. For the 7-
segment LED status display of the servo amplifier, refer to "Status display" in the following manual.
MR-J5-A User's Manual (Introduction)
5.1

Explanation of monitor signals

The name and description of the monitor signals used in the servo amplifier and the signal block diagram are shown as
follows.

Name and description of the monitor signals

The following show the types of monitor signals.
Monitor
Monitor signal (analog)
Monitor signal (digital)
Analog monitor
This chapter shows the name and description of each of monitor signals. The unit and others may differ depending on the
control mode and display method. For "Display all" and the display of the graph in the monitor, refer to the following.
Page 236 Checking with MR Configurator2
For the analog monitor, refer to the following.
Page 239 Analog monitor [G] [WG]
Page 243 Analog monitor [A]
5 MONITOR
228
5.1 Explanation of monitor signals
Description
The data indicated in analog form, such as the servo motor speed
The data indicated by on and off of bits, such as INP (In-position)
The data to output the servo amplifier status using voltage