Raven ISO Product Controller II Operation Manual page 73

Table of Contents

Advertisement

Code ID
.0
.1
.4
.13
.15
3132
.16
.17
.18
4305
.2
Troubleshooting: Diagnostic Trouble Code (DTC) List
Description
Maximum pressure exceeded
System pressure not detectable.
Pressure transducer not detected
Pressure transducer not
calibrated
Monitored system pressure
higher than maximum pressure
set-point
Monitored system pressure
higher than the target pressure
deadband
Monitored system pressure lower
than minimum pressure set-point
Monitored system pressure lower
than the target pressure
deadband
Equipment speed is below
operational range
Recommended Actions
1. Relieve pressure from system. Check the
boom pressure transducer calibration
settings.
1. Activate product pump.
2. Check for system leaks.
3. Increase pump output to maintain a boom
pressure above 2 PSI [13.8 kPa].
1. Check the pressure transducer connection.
2. Check the transducer cabling for damage and
replace the cable if necessary.
1. Refer to the Tools Menu Settings Definitions
section on page 22 for assistance with the
pressure transducer calibration.
1. Reduce the equipment speed.
2. Refer to the System Settings Tab - Pressure
section on page 34 for assistance with
adjusting the maximum pressure set-point.
1. Reduce the equipment speed.
2. Refer to the Pressure 1 and 2 Presets section
on page 31 for assistance with setting or
adjusting the target pressure.
3. Refer to the System Settings Tab - Pressure
section on page 34 for assistance with setting
or adjusting the off pressure percent.
1. Increase the equipment speed.
2. Refer to the System Settings Tab - Pressure
section on page 34 for assistance with
adjusting the minimum pressure set-point.
1. Increase the equipment speed.
2. Refer to the Pressure 1 and 2 Presets section
on page 31 for assistance with setting or
adjusting the target pressure.
3. Refer to the Pressure 1 and 2 Presets section
on page 31 for assistance with setting or
adjusting the off pressure percent.
1. Increase vehicle speed.
TROUBLESHOOTING
63

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ISO Product Controller II and is the answer not in the manual?

This manual is also suitable for:

Hawkeye

Table of Contents

Save PDF