Raven ISO Product Controller II Operation Manual page 114

Table of Contents

Advertisement

A
E
PPENDIX
3. Clean contacts with a small wire brush (P/N 321-0000-477).
4. Spray the contacts again with the deoxidizing agent. This will rinse out debris.
5. Remove all residue of deoxidizing agent from the connection. Not removing deoxidizing agent can damage
the connector seal.
6. Dry out the connection with dry, compressed air. Dust Off Electronics Duster (P/N 222-4001-007) is
recommended however, if unavailable, alternate compressed air sources can be used. If using compressed air
from a large volume air compressor, be sure the lines are free of moisture.
104
ISO Product Controller II and Hawkeye Operation Manual

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ISO Product Controller II and is the answer not in the manual?

This manual is also suitable for:

Hawkeye

Table of Contents

Save PDF