Table of Contents
Advertisement
INSTALLATION
2.3
E700 Installation Procedure
32
1) Remove the inverter's front cover.
2) Securely attach the option card to
the inverter's option connector. Ensure
that the option card is fully seated on
the option connector.
3) Secure the upper-left corner of the
option card with the included M3x6mm
pan head mounting screw. Secure the
lower-right corner of the option card
with the included M3x20mm flat head
mounting screw.
4) Tighten both mounting screws to a
torque setting of 0.33 N·m to 0.40 N·m.
REMOVAL
First remove the M3x6mm and
M3x20mm mounting screws. Lastly,
remove the option board by grasping it
on its left and right side and pulling it
straight away from the inverter.
Hide quick links:
Advertisement
Table of Contents
