Controllogix Example: Eds Add-On Profile (Aop) - Mitsubishi 700 Series Instruction Manual

7) Assign the Ethernet module a name
(we will use "EIP") and an IP address,
deselect "Open Module Properties",
and click OK.
8) Assign the Ethernet module a name
(we will use "EIP") and an IP address,
deselect "Open Module Properties",
and click OK.
9) Download the configuration.
10) Switch to online mode. Right click on
the 1756-ENBT module in the I/O
Configuration and choose
"Properties".
11) Select the Internet Protocol tab from
the Module Properties dialog box and
confirm that the IP Settings are
configured correctly.

9.2.11 ControlLogix Example: EDS Add-On Profile (AOP)

This section will demonstrate how to setup and use an EtherNet/IP I/O connection via EDS Add-On
Profile. This example only applies to RSLogix5000 V20 (and later) that support EDS Add-On Profile.
PROTOCOL-SPECIFIC INFORMATION
Figure 31: Identifying the New Module
9
129