REGISTER NUMBERING AND BEHAVIOR
4.3
Inverter Command Register
The command word is register 1 and the bit-mapping is described in Table 19. Refer to the specific
inverter user manual to confirm the bit-mapping and signal settings.
*1
The signal within parentheses is the initial setting. The description changes depending on the setting
of Pr. 180 to Pr. 184, Pr. 187 (input terminal function selection).
*2
The signal within parentheses is the initial setting. Since jog operation/selection of automatic restart
after instantaneous power failure/start selfholding/reset cannot be controlled by the network, bit 8 to bit
52
Table 19: Inverter Command Register