Siemens Sinamics CU240D-2 DP Operating Instructions Manual page 59

Cable, connectors and tools specifications
The detailed specifications for the cables, connectors and tools required to manufacture the
necessary cables for the SINAMICS G120D are listed in the following tables. The
connections that are detailed in this section relate to the physical connections that exist on
the Inverter. Information for the preparation and construction of the individual connectors
have separate detailed instructions delivered with the ordered parts, direct from the
manufacturers. Use 75 °C copper wire only.
Note
NFPA compatibility
These devices are intended only for installation on industrial machines in accordance with
the "Electrical Standard for Industrial Machinery" (NFPA79). Due to the nature of these
devices they may not be suitable for installation accordance with the "National Electrical
Code" (NFPA70).
Table 4- 10
Crimp tool (Q8/0 and Q4/2)
Removal tool (Q8/0)
Removal tool (Q4/2)
No special tools are required for the Control Unit connectors
Table 4- 11
Connector
24 V DC power supply In (7/8")
24 V DC power supply Out (7/8")
PROFIBUS In (M12)
PROFIBUS Out (M12)
PROFINET Port 1 and Port 2 (M12)
Digital input and output
Encoder (M12), analog input (M12)
You find information about KnorrTec in the internet:
Converter with the control units CU240D-2
Operating Instructions, 04/2018, FW V4.9 SP10, A5E34262100B AF
Tools
Article number
3RK1902-0AH00
3RK1902-0AJ00
Harting part number 0999-000-0305
Control unit connectors
Article number
Straight connector
6GK1905-0FB00
6GK1905-0FA00
6GK1905-0EB00
6GK1905-0EA00
6GK1901-0DB20-6AA0
3RK1902-4BA00-5AA0
Via KnorrTec
Installation
4.2 Electrical Installation
Right-angle connector
3RK1902-3DA00
3RK1902-3BA00
3RK1902-1DA00
3RK1902-1BA00
3RK1902-2DA00
3RK1902-4DA00-5AA0
57