Thermo Scientific Dionex Aquion RFIC Operator's Manual page 136

6
Service
Replacing the Dionex EGC Holder and Degas Assembly
120 Dionex Aquion RFIC Operator's Manual
Figure 80. Dionex CR-TC installed in Dionex EGC holder
7. Feed the Dionex CR-TC electrical cable through the slot on the side of the Dionex EGC
holder (see Figure 81).
Figure 81. Dionex CR-TC electrical cable
8. Turn the Dionex EGC holder right-side up and set it on top of the Dionex Aquion RFIC.
9. Direct the
WASTE, GAS SEPARATOR
the rear panel. Snap the line onto one of the tubing clips on the rear panel. Connect the
line to the gas separator waste tube assembly installed on the waste container.
10. Feed the following liquid lines from the bottom of the Dionex EGC holder, through the
tubing chase, to the Dionex Aquion RFIC component panel:
•
TO SRS/AES REGEN OUT
•
TO INJ VALVE IN - P/ELUENT OUT
•
TO PUMP/DAMPER
CR-TC electrical cable
line from the top of the Dionex Aquion RFIC to
Thermo Scientific