Adjusting The Tension Of The Dryer Drive Belt - Kodak M6B Service Manual

Adjusting the Tension of the Dryer Drive Belt

[1] Check that:
• the processor is operating
• the DRYER TEMPERATURE CONTROL KNOB is in the full counterclockwise
• the DRYER is cool.
[2] Adjust the tension of the DRYER DRIVE BELT by doing the following:
• Disconnect the main power.
• Loosen the LOCKING PIVOT SCREW.
• Loosen the ADJUSTING SCREW LOCK NUT.
• Rotate the ADJUSTING SCREW to tighten the DRYER DRIVE BELT until the ROLLERS just begin to
rotate.
• Rotate the ADJUSTING SCREW an additional 1 rotation.
• Tighten the LOCKING PIVOT SCREW.
• Tighten the ADJUSTING SCREW LOCK NUT.
AIR
TUBE
246628
Moving parts.
BELT
LOCKING
SCREW LOCKNUT
ROLLER
ASSEMBLY
Figure 36 Adjusting the Tension of the Dryer Drive Belt
SCREW
ADJUSTING
ADJUSTING
SCREW KNOB
position
H048_0093BCA
H048_0093BA
2-31