Developer Filter; Removing And Replacing The Developer Filter - Kodak M6B Service Manual

Developer Filter

The DEVELOPER FILTER CANISTER is pressurized when the processor is energized.

Removing and Replacing the Developer Filter

[1] Deenergize the processor before proceeding.
[2] Turn the CAP counterclockwise
[3] Rotate the TABS counterclockwise
[4] Lift off the CAP.
[5] Remove and discard the old FILTER.
[6] Install the new FILTER.
[7] Wet the O-RING with water.
[8] Install the CAP by rotating the TABS to engage the LOCKS. Then tighten the CAP.
246628
until it stops.
to disengage the LOCKS.
CAP
TAB
O-RING
FILTER
Figure 47 Replacing the Developer Filter
H048_0136BCA
H048_0136BA
2-43