Table of Contents
Advertisement
Connecting the HOSES from the REPLENISHMENT TANKS
in Table Top or MOUNTING STAND Installations
[1] Check that all 3 DRAIN VALVES are closed.
[2] Remove the tape securing the REPLENISHMENT HOSES.
Note
If you are installing the PROCESSOR through the darkroom wall, see "Installing the PROCESSOR Through the
Wall" on Page 13.
[3] Route the REPLENISHMENT HOSES through the HOLES in the base of the PROCESSOR.
Note
• HOSES for connecting the REPLENISHMENT TANKS to the REPLENISHMENT HOSES on the
PROCESSOR are not packed with the PROCESSOR. Use standard
• Use a small HOSE CLAMP (provided with M43 and M43A only).
• The FITTING on the fixer REPLENISHMENT HOSE has a blue WIRE TIE for easy identification.
The FITTING on the developer REPLENISHMENT HOSE has a red WIRE TIE for easy identification.
Connecting the REPLENISHMENT HOSES
Figure 45
WATER INPUT
SOLENOID
[4] Connect the fixer REPLENISHMENT HOSE on the PROCESSOR to the fixer REPLENISHMENT TANK.
[5] Install a STRAINER ASSEMBLY in the fixer REPLENISHMENT HOSE near the REPLENISHMENT
TANK.
[6] Connect the developer REPLENISHMENT HOSE to the developer REPLENISHMENT TANK.
[7] Install a STRAINER ASSEMBLY in the developer REPLENISHMENT HOSE near the REPLENISHMENT
TANK.
981088 – September 1995
developer
DRAIN VALVE
fixer
DRAIN VALVE
STEM
Making the Necessary Connections
⁄
3
-in. tubing.
8
fixer
REPLENISHMENT
HOSE
developer
REPLENISHMENT
HOSE
blue WIRE TIE
red
WIRE
TIE
FITTING
(2)
H130_0112HCB
H130_0112HA
53
Advertisement
Table of Contents
