Pd (Pull Up/Down Direction); Io (Set Digital I/O Lines); M0 (Pwm0 Duty Cycle) - Digi XBee3 DigiMesh 2.4 User Manual

AT commands
Bit I/O line
15 DIO15
16 DIO16
17 DIO17
18 DIO18
19 DIO19
Parameter range
Through-hole: 0 - 0xFFFF
SMT/MMT: 0 - 0xFFFFF
Default
0xFFFF

PD (Pull Up/Down Direction)

The resistor pull direction bit field (1 = pull-up, 0 = pull-down) for corresponding I/O lines that are set
by the PR command.
See PR (Pull-up/Down Resistor Enable)
Parameter range
Through-hole: 0 - 0xFFFF
SMT/MMT: 0 - 0xFFFFF
Default
0xFFFF

IO (Set Digital I/O Lines)

Sets digital output levels. This allows DIO lines setup as outputs to be changed through Command
mode.
Parameter range
8-bit bit map; each bit represents the level of an I/O line set up as an output
Default
N/A

M0 (PWM0 Duty Cycle)

The duty cycle of the PWM0 line (Micro pin 7/SMT pin 7).
If IA (I/O Input Address)
PWM0 output, incoming AD0 samples automatically modify the PWM0 value. See
Timeout).
To configure the duty cycle of PWM0:
Digi XBee3® DigiMesh 2.4 RF Module User Guide
Micro pin Surface-mount pin
16 17
15 16
14 15
13 14
11 12
for the bit mappings.
is set correctly and P0 (DIO10/RSSI/PWM0 Configuration)
I/O settings commands
Through-hole pin
N/A
N/A
N/A
N/A
N/A
is configured as
PT (PWM Output
150