D9 (Dio9/On_Sleep Configuration); P0 (Dio10/Rssi/Pwm0 Configuration) - Digi XBee3 DigiMesh 2.4 User Manual

AT commands
Parameter Description
DTR/Sleep_Request (used with pin sleep and cyclic sleep with pin wake)
1
2 N/A
3 Digital input
4 Digital output, low
5 Digital output, high
Default
1

D9 (DIO9/ON_SLEEP Configuration)

Sets or displays the DIO9/ON_SLEEP configuration (Micro pin 25/SMT pin 26/TH pin 13).
Parameter range
0, 1, 3 - 5
Parameter
0
1
2
3
4
5
Default
1

P0 (DIO10/RSSI/PWM0 Configuration)

Sets or displays the DIO10/RSSI/PWM0 configuration (Micro pin 7/SMT pin 7/TH pin 6).
When configured as RSSI PWM output, the device outputs a PWM signal with a duty cycle equivalent to
the dBm of the received packet.
Use RP command
When configured as PWM output (2): you can use M0 to explicitly control the PWM0 output. When used
with Analog line passing, PWM0 corresponds with ADC0.
Parameter range
0 - 5
Digi XBee3® DigiMesh 2.4 RF Module User Guide
Description
Disabled
ON/SLEEP indicator
N/A
Digital input
Digital output, low
Digital output, high
to configure the timeout.
I/O settings commands
147