T6 (D6 Output Timeout); T7 (D7 Output Timeout); T8 (D8 Timeout); T9 (D9 Timeout) - Digi XBee3 DigiMesh 2.4 User Manual

AT commands

T6 (D6 Output Timeout)

Specifies how long pin
value. If set to 0, there is no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

T7 (D7 Output Timeout)

Specifies how long pin
value. If set to 0, there is no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

T8 (D8 Timeout)

Specifies how long pin
to configured value. If set to 0, there is no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

T9 (D9 Timeout)

Specifies how long pin
configured value. If set to 0, there is no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

Q0 (P0 Timeout)

Specifies how long pin P0 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Digi XBee3® DigiMesh 2.4 RF Module User Guide
D6 (DIO6/RTS Configuration)
D7 (DIO7/CTS Configuration)
D8 (DIO8/DTR/SLP_Request Configuration)
D9 (DIO9/ON_SLEEP Configuration)
I/O line passing commands
holds a given value before it reverts to configured
holds a given value before it reverts to configured
holds a given value before it reverts
holds a given value before it reverts to
157