N? (Network Discovery Timeout); Security Commands; Ee (Encryption Enable); Ky (Aes Encryption Key) - Digi XBee3 DigiMesh 2.4 User Manual

AT commands
Default
N/A

N? (Network Discovery Timeout)

The maximum response time, in milliseconds, for ND (Network Discovery) responses and DN (Discover
Node) responses. The timeout is the sum of NT (Network Discovery Back-off Time) and the network
propagation time.
Parameter range
This is a read-only parameter, however, its value increases or decreases as NT increases or
decreases and you can modify NT.
Default
N/A

Security commands

The following commands enable and control the encryption used for RF transmissions.

EE (Encryption Enable)

Enables or disables Advanced Encryption Standard (AES) encryption. See bit 2 of
Options), which controls the encryption mode.
Set this command parameter the same on all devices in a network.
Parameter range
0 - 1
Parameter
0
1
Default
0

KY (AES Encryption Key)

The Link Key used for encryption and decryption. If
encryption/decryption uses the 256 bits of the KY value (all 64 ASCII characters of the KY value). C8 bit
2 sets encryption/decryption, and uses the last 32 ASCII characters of the 256-bit KY value entered.
This command is write-only and cannot be read. If you attempt to read KY, the device returns an OK
status.
Set this command parameter the same on all devices in a network.
Parameter range
256-bit value (up to 32 hex bytes/64 ASCII bytes)
Digi XBee3® DigiMesh 2.4 RF Module User Guide
Description
Encryption Disabled
Encryption Enabled
C8 (Compatibility Options)
Security commands
C8 (Compatibility
bit 2 is cleared,
123