Pd (Pull Up/Down Direction); Lt Command - Digi XBee3 802.15.4 User Manual

AT commands
Bit I/O line
7 UART_DIN
8 DIO5/Associate
9 DIO9/Awake_nSleep
10 DIO12
11 DIO10/PWM-RSSI
12 DIO11
DIO7/ CTS
13
14 UART_DOUT
15 DIO15
16 N/A
17 N/A
18 N/A
19 N/A
Parameter range
0 - 0xFFFFF (bit field)
Default
0xFFFF
Example
Sending the command ATPR 6F turn bits 0, 1, 2, 3, 5 and 6 ON, and bits 4 and 7 OFF. The binary
equivalent of 0x6F is 01101111. Bit 0 is the right-most digit in the binary bit field.

PD (Pull Up/Down Direction)

See PR (Pull-up/Down Resistor Enable)
Parameter range
0 - 0xFFFFF (bit field)
Default
0xFFFF

LT command

Set or read the Associate LED blink time. If you use
Associate LED functionality (DIO5/Associate pin), this value determines the on and off blink times for
the LED when the device has joined the network.
If LT = 0, the device uses the default blink rate: 500 ms for a sleep coordinator, 250 ms for all other
nodes.
XBee3® 802.15.4 RF Module User Guide
for the bit mappings.
D5 (DIO5/Associate Configuration)
I/O settings commands
to enable the
54