Notes For Energy Save Mode Setting; Ip Address Setting - Ricoh Da-P1 Field Service Manual

2. Installation
No.
1 Green and Yellow
2
3

Notes for Energy Save Mode Setting

If the machine that has this option enters into the energy save mode, you cannot print because there will
be a communication error. Follow the instructions below to set the machine to disable entering into the
energy save mode.
1. Press [Features Settings] on the operation panel.
RTB 14
2. Press [Administrator Tools] in [System Settings].
Replace this
procedure
3. Press [Energy Saver Mode to Disable Print Server].
4. Press [Disable Mode].
5. Press [OK].
6. Press [Features Settings].

IP Address Setting

This section describes how to set an IP address on this option manually. Note that you can set an IP
address which is not only on the same network segment but also on a different network segment to share
a single printer with devices in multiple networks.
• You cannot change the IP address for this option from the operation panel of the main machine.
The setting must be done from a web browser on your PC.
• The network setting of this option is initially assigned as follows:
IP address: 192.168.100.100 / Subnet mask: 255.255.255.0
• The network setting of your PC must be in the same network segment to change the network setting
of this option.
1. Make a note of the current network settings of your PC.
2. Change the IP address on your PC to [192.168.100.xxx (*0 - 255)].
3. Change the subnet mask on your PC to [255.255.255.0].
4. Open a web browser.
5. Type [http://192.168.100.100/] in the address bar.
36
Light Color
1000BASE-T operates
Green 10BASE-T operates
Yellow 100BASE-TX operates
Lights Up When: