Table of Contents
Advertisement
9.
Enter the machine serial number (SP-811-001).
• For information on how to configure SP5-811-001, contact your supervisor or support center.
10.
Set the machine state destination (SP-996-001).
• For information on how to configure SP5-996-001, contact your supervisor or support center.
11.
Turn the main power switch off and on.
• If the BCU serial number is not entered correctly, SC995-01 (serial number entry error)
appears.
12.
Execute SP5-825-001 to download the EEPROM data in the SD onto the new EEPROM.
13.
Turn off the main power switch.
14.
Remove the SD card from SD card slot 2.
15.
Turn the main power switch on.
16.
In accordance with SMC data, specify the UP and SP mode settings.
Toner End Sensor
1.
Left Cover
(page
58)
2.
Toner End Sensor [A] (
×1,
×1, Tab×1)
Electrical Components
139
Advertisement
Chapters
Table of Contents
Troubleshooting
