Ricoh Da-P1 Field Service Manual page 29

• If you have to move the machine when the optional paper tray unit is attached, do not push on the
main unit's top section. Doing so can cause the optional paper tray unit to detach, possibly resulting
in injury.
• When disconnecting the power cord from the wall outlet, always pull the plug, not the cord. Pulling
the cord can damage the power cord. Use of damaged power cords could result in fire or electric
shock.
• The machine weighs approximately 22.5 kg (49.6 lb.). When moving the machine, use the inset
grips on both sides, and lift slowly in pairs. The machine will break or cause injury if dropped.
• Do not hold the control panel while moving the machine. Doing so may damage the control panel,
cause a malfunction, or result in injury.
• Be careful when moving the machine. Take the following precautions:
• Close all covers and trays, including the front cover and by-pass tray.
• If optional paper feed units are attached, remove them from the machine and move them
separately.
• Keep the machine level and carry it carefully, taking care not to jolt or tip it. Rough handling may
cause a malfunction or damage the hard disk or memory, resulting in loss of stored files.
1. Be sure to check the following:
The main power switch is turned off.
The power cord is unplugged from the wall outlet.
The interface cable is unplugged from the machine.
2. If any external options are attached, remove them.
3. Lift the machine using the inset grips on both sides of the machine. And then move it
horizontally to the place where you want to use it.
4. If you removed options, reattach them.
• Be sure to move the machine horizontally. To prevent toner from scattering, move the machine
slowly.
Main Machine Installation
27