Ricoh Da-P1 Field Service Manual page 214

6. Troubleshooting
SC No.
212
Level Error Name/Error Condition/Major Cause/Solution
A hard disk is connected, but the driver detected the following errors:
SS_NOT_READY
(-2) The HDD is not ready.
SS_BAD_LABEL
(-4) Incorrect partition type.
SS_READ_ERROR
(-5) An error occurred while reading or checking labels.
SS_WRITE_ERROR
(-6) An error occurred while writing or checking labels.
SS_FS_ERROR
(-7) Failed to restore filesystem.
SS_MOUNT_ERROR
(-8)Failed to mount filesystem.
SS_COMMAND_ERROR
(-9) The driver does not respond to the command.
SS_KERNEL_ERROR
(-10) Internal kernel error.
SS_SIZE_ERROR:
(-11)The drive is too small.
SS_NO_PARTITION: (-12) The specified partition does not exist.
SS_NO_FILE
No device file exists.
Tried to obtain the information about the status of the hard disk from the
driver, but no response has been returned for more than 30 seconds.
• The hard disk has not yet initialized.
• Broken label data
• Defective hard disk
Initialize the hard disk from SP mode.