Motor Data; Hand Mode Configuration; Motor Power; Motor Voltage/Motor Frequency - Danfoss VLT FC 51 Series Programming Manual

VLT Micro Drive FC 51

1-05 Hand Mode Configuration

Option:
[0]
*
[2]

4.2.1. 1-2* Motor Data

Enter the correct motor nameplate data (power, voltage, frequency, current and speed).
Run AMT, see par. 1-29.
Factory settings for advanced motor data, par. 1-3*, are automatically calculated.
1-20 Motor Power [kW]/[HP] (P
Range:
1-22 Motor Voltage (U
Range:
230/400
V
1-23 Motor Frequency (f
Range:
50 Hz
Function:
This parameter is only relevant when parameter 1-00
ration Mode
used for determining the reference or setpoint handling when
changing from Auto Mode to Hand Mode on the LCP.
Speed Open Loop In Hand Mode the drive always runs in Open Loop configuration
regardless of setting in par. 1-00
tentiometer (if present) or Arrow up/down determines output
frequency limited by Motor Speed High/Low Limit (parameters
4-14 and 4-12).
As configuration in If par. 1-00
par. 1-00 is as described above.
If par. 1-00 is set to
mode to Hand mode results in a setpoint change via local po-
tentiometer or Arrow up/down. The change is limited by Refer-
ence Max/Min (parameters 3-02 and 3-03).
NB!
Parameters in parameter group 1.2* cannot be adjusted while motor runs.
Function:
Enter motor power from nameplate data.
[0.09 kW/0.12 HP - Two sizes down, one size up from nominal VLT rating.
11 kW/15 HP]
)
m.n
Function:
[50 - 999 V] Enter motor voltage from nameplate data.
)
m.n
Function:
*
[20-400 Hz] Enter motor frequency from nameplate data.
MG.02.C2.02 - VLT ® is a registered Danfoss trademark
is set to Process Closed Loop
Configuration Mode
Configuration Mode
is set to
Process Closed Loop
)
m.n
NB!
Changing this parameter affects par. 1-22 to 1-25,
1-30, 1-33 and 1-35.
4. Parameter Descriptions
Configu-
[3]. The parameter is
. Local po-
Open Loop
[1] function
[3] changing from Auto
4
19