Parameter Descriptions; Parameter Group 0: Operation/Display; 0-1 Set-Up Handling - Danfoss VLT FC 51 Series Programming Manual

VLT Micro Drive FC 51

4. Parameter Descriptions

4.1. Parameter group 0: Operation/Display

0-03 Regional Settings
Option:
*
[0 ]
[1]
0-04 Operating State at Power-up (Hand Mode)
Option:
[0]
*
[1]
[2]
4.1.1. 0-1* Set-up Handling
User defined parameters and miscellaneous external inputs (eg. bus, LCP, analog/digital inputs,
feedback, etc.) controls the functionality of the frequency converter.
A complete set of all parameters controlling the frequency converter is called a set-up. The Micro
Drive FC 51 contains 2 set-ups,
Function:
In order to meet the needs for different default settings in dif-
ferent parts of the world, par. 0-03,
mented in the frequency converter. The selected setting
influences the default setting of the motor nominal frequency.
International Sets default of par. 1-23,
US Sets default of par. 1-23,
Function:
This parameter controls whether or not the frequency converter
should start running the motor when powering up after a power
down in Hand mode.
Resume Frequency converter starts in same Hand or Off State as when
powered off.
Local reference is stored and used after power-up.
Forced Stop, Ref=Old Frequency converter powers up in Off State meaning that motor
is stopped after power up.
Local reference is stored and used after power-up.
Forced Stop, Ref=0 Frequency converter powers up in Off State meaning that motor
is stopped after power up.
Local reference is set to 0. Thus motor will not start running
before local reference has been increased.
Set-up1
MG.02.C2.02 - VLT ® is a registered Danfoss trademark
Motor Frequency
Motor Frequency
NB!
This parameter cannot be adjusted while motor
runs.
NB!
If LCP with potmeter is mounted, reference is set
according to actual potmeter value.
Set-up 2
and .
4. Parameter Descriptions
Regional Settings , is imple-
, to 50 Hz.
, to 60 Hz.
4
13