0-4 Lcp Keypad; Link Set-Ups - Danfoss VLT FC 51 Series Programming Manual

VLT Micro Drive FC 51
[9]

0-12 Link Set-ups

Option:
[0]
*
[1 ]
4.1.2. 0-4* LCP Keypad
The frequency converter can operate in the following three modes:
Hand:
activating Hand a start signal is given.
OFF:
The frequency converter stops with a normal stop ramp. When Off is chosen the frequency
converter can only be started by pressing either Hand or Auto on the LCP.
Auto:
In Auto-mode the frequency converter can be remote controlled (bus/digital).
0-40 [Hand on] Key on LCP
Option:
[0]
*
[1 ]
0-41 [Off/Reset] Key on LCP
Option:
[0]
*
[1 ]
[2]
0-42 [Auto on] Key on LCP
Option:
[0]
*
[1 ]
Active Set-up Update parameters in set-up selected as
0-10).
Function:
The link ensures synchronizing of the "not changeable during
operation" parameter values enabling shift from one set-up to
another during operation.
If the set-ups are not linked, a change between them is not
possible while the motor is running. Thus the set-up change
does not occur until the motor is coasted.
Not linked Leaves parameters unchanged in both set-ups and cannot be
changed while motor runs.
Linked Copy parameters "not changeable during operation" parameter
values into presently selected
The frequency converter is locally operated and does not allow any remote control. By
Function:
Disabled Hand-on key has no function.
Enabled Hand-on key is functional.
Function:
Disable Off/Reset Off/reset key has no function.
Enable Off/Reset Stop signal and reset of any faults.
Enable Reset Only Reset only. Stop (Off) function is disabled.
Function:
Disabled Auto-on key has no function.
Enabled Auto-on key is functional.
MG.02.C2.02 - VLT ® is a registered Danfoss trademark
4. Parameter Descriptions
Active Set-up
Edit Set-up
NB!
This parameter cannot be changed while motor
runs.
Hand , Off
(see par.
.
and Auto .
15
4