0-5 Copy/Save; 0-6 Password; Lcp Copy/Set-Up Copy; (Main) Menu Password - Danfoss VLT FC 51 Series Programming Manual

4. Parameter Descriptions
4.1.3. 0-5* Copy/Save
0-50 LCP Copy
Option:
4
[1]
[2]
[3]
0-51 Set-up Copy
Option:
[0 ]
[1]
[2]
[9]
4.1.4. 0-6* Password

0-60 (Main) Menu Password

Range:
16
Function:
The detachable LCP of the frequency converter can be used for
storing setups, and thus for transferring data when moving pa-
rameter settings from one frequency converter to another.
All to LCP Copy all setups from the frequency converter into the LCP.
All from LCP Copy all setups from LCP to frequency converter.
Size indep. from LCP Copy non motor size dependent data from LCP to frequency
converter
Function:
Use this function to copy a set-up content into the
In order to be able to make a set-up copy ensure that
* No Copy Copy function is inactive
Copy from Set-up 1 Copy from
up
Copy from Set-up 2 Copy from
up
Copy from Factory Copy from Factory Settings to edit set-up chosen in par. 0-11,
Edit set-up
Set-up
Function:
Use password for protection against unintended change of sen-
sitive parameters, eg. motor parameters.
Password protected parameters can always be read, but cannot
be edited without entering the password.
MG.02.C2.02 - VLT
NB!
LCP Copy
can only be activated from the LCP and
ONLY when the motor is coasted.
• the motor is coasted
Active Set-up
• par. 0-10,
Set-up 2
or [2]
NB!
The keyboard/parameter database are blocked
while Set-up Copy is running.
Set-up 1
to edit set-up chosen in par. 0-11,
.
Set-up 2
to edit set-up chosen in par. 0-11,
.
.
® is a registered Danfoss trademark
VLT Micro Drive FC 51
Edit Set-up
Set-up 1
, is set to either [1]
Edit Set-
Edit Set-
.