Table of Contents
Advertisement
Installation
Guidelines
Space Requirements
Electrical Requirements
5
ECL Imager User Manual
MY
Imager
Chapter 2
IMPORTANT Review and implement guidelines for proper set-up before installation.
Locate the imager away from water, solvents, corrosive materials, strong magnetic
fields and vibration sources.
IMPORTANT The imager weighs 65lbs (29.5kg). Use two people to lift it by grasping
the bottom and the handle at the rear of the imager. Using two people, place the
imager onto the benchtop given proper space, electrical and environmental
requirements. Remove the outer and inner packaging materials.
The imager requires a stable laboratory bench or table capable of supporting 65lbs
(29.5kg). Provide a minimum clearance of 3 inches (7.62cm) at the rear of the
imager to allow adequate ventilation for camera cooling and access to the power
cord and switch. In addition, allow sufficient space to open the front-facing imager
door to place sample within the imager. Instrument dimensions are listed in
Table 2-1.
Table 2-1. Imager dimensions.
Dimensions
Inches
Width
12.25
Depth
22
Height
21
A grounded circuit capable of delivering the appropriate current and voltage is
required for installation. Electrical requirements can be located on the imager label
on the rear panel of the imager and in Table 2-2. The imager electrical system
adjusts to the proper voltage for the respective country (Table 2-3). Connect the
imager power cord to the rear left side panel of the system and plug into a grounded
power outlet.
Centimeters
31.1
55.9
53.3
Thermo Fisher Scientific
Advertisement
Table of Contents
