Routing Page - Sony SIU-100 Operating Instructions Manual

Making Settings Using a Personal Computer

Routing Page

This page allows you to confirm the routing settings
connecting the input channels and output channels or
input slots. In Edit Mode, you can assign routings in
units of channels or in units of slots. You can make the
same settings as those you make using the ROUTING
menu of the SIU-100/100T.
Displaying routing in units of slots (8
channels)
Click [Slot to Slot] next to the Routing label.
Slot to slot
The SLOT to SLOT ROUTING window appears.
Using this window, you can confirm the current
routing status between slots.
The mark displayed indicates that the 8 input channels and
8 output channels are connected.
N.C. column: When the mark is
displayed here, the corresponding
output channels are not routed to
any channels.
ch-ch column: One or more channels of the 8 channels
of the corresponding slot are routed to output channels
in units of channels.
For the DMBK-R109, 56 channels are divided into 7
groups, treating 8 channels as one group.
128
Setting the routings in units of slots
The Edit Mode of the Routing page allows you to set
the routing in units of slots.
1
Click the radio button corresponding to the cross
point of the input slot and output slot to be routed.
Currently routed (displayed in a dark color)
Not yet connected, but the radio button was clicked in step
1 shown as. (The mark appears and the box is displayed in
a light color.)
For a point where routing is impossible, the radio
button is not displayed.
The cross points currently routed are displayed
darker than points which are not routed.
You can assign multiple output channels to one
input channel.
Note
Even though channels are routed in units of
channels, if slots are routed in units of slots on this
page, previous routings are overwritten.
2
Make settings for remaining routings by repeating
operations from step 1.
To clear the routing of 8 channels at one
time
Click the button corresponding to the slot to be
cleared on the N.C. row.
3
Click the [APPLY] button.
The settings are executed.
To cancel the operations performed in
steps 1 and 2
Click the [CANCEL] button instead of the
[APPLY] button. Settings are reset to the previous
ones.