Sony SIU-100 Operating Instructions Manual page 122

Menu Operations
3
Change the setting of the item selected in step 2.
To set IP ADDRESS, GATWEAY and
SUBNET MASK
1 Move the cursor to each area in turn using the
B and b buttons, and enter a 3 digit value using
the ten key pad.
The area where the numerical value has been
changed blinks.
2 Push the ENTER button after you have entered
all of addresses.
The various areas stop blinking.
To set NAME and PASSWORD
Move the cursor using the B and b buttons and
enter the characters using ten key pad and the +/–
buttons.
The characters you can enter are the same as those
for the name of the scene.
For details, see "Characters that can be entered" on
page 108.
Note
When you change the IP address, turn the power of the
SIU-100/100T off once, and then turn it on again.
122
Setting the display method of the
channels on the SIU-RM101 (option)
When a DMBK-S101 inserted into an SIU-100/100T is
controlled using the SIU-RM101 remote control unit,
you can select the method used to display the channel
numbers of the microphone inputs displayed on the
panel of the SIU-RM101.
The following two methods are available.
• SL & CH
Displays the numbers of the slots where the DMBK-
S101 is inserted, using numbers from 1 to 8, and also
displays the channel number.
• SERIAL
Displays the numbers of channels in a series, from 1
to 64, of the microphone inputs of the DMBK-S101s
which are installed in the SIU-100/100T. In this
mode, assign numbers to the 8 channels of each
board.
1
Enter the SIU-RM101 submenu by displaying it on
the LCD.
2
Move the cursor to the upper row by pushing the V
button and select the display mode using the +/–
buttons.
If you select SERIAL, go to step 3.
3
Move the cursor by pushing the v button and
assign a channel number.
1 Move the cursor to the slot number area using
the B button and assign a slot number using the
ten key pad or the +/– buttons.
At this time, the channel number assigned to
that slot number is displayed.
2 Move the cursor using the b button and change
the channel numbers to the one assigned to that
slot number selected in step 1 using the +/–
buttons.
3 Assign the channel numbers of the remaining
DMBK-S101 boards repeating steps 1 and
2.
To close the SIU-RM101 submenu
Push the SETUP button. The SETUP button indicator
goes off and the normal window appears.