Sony SIU-100 Operating Instructions Manual page 116

Menu Operations
Setting the INPUT monitor display
The LED DISPLAY submenu allows you to set the
display mode of the INPUT monitor display on the
front panel.
For detailed information on the INPUT monitor display, see
" LCD - Nomarl operating display " on page 92.
1
Enter the LED DISPLAY submenu by displaying
it on the LCD.
2
Select the items to be set by changing the display
on the lower row using the V or v buttons.
The setting window changes in the following
sequence: MODE y TH_RED y TH_GRN.
3
Change the setting of the item selected in step 2.
When MODE has been selected in step 2:
Select either STATUS mode or METER mode
using the +/– buttons.
When the METER mode is selected, move the
cursor by pressing the b button and select the slot
number to be displayed in the METER mode using
the +/– buttons.
When TH_RED has been selected in step 2:
Set the threshold level where the LED lights in red.
When the level of the input signal exceeds the
value set here, the LED lights in red.
When TH_GRN has been selected in step 2:
Set the threshold level to where the LED lights in
green. In STATUS mode, if the input signal
exceeds the value set here, the LED lights in green.
In the METER mode, the setting of TH_GRN
makes no difference.
116
Note
Normally, when the red level is set higher than the
green level, the LED lights in order of not lit t lit
in green t lit in red. If the red level is set lower
than the green level, the LED lighting condition
changes to 2 stages, that is, the LED lights in order
of not lit or lights in red.
When an SIU-RM101 remote control unit is
used
Settings performed on this LED DISPLAY submenu
are applied to the lighting criteria for the SIGNAL/
OVER indicator on the SIU-RM101.
Confirming/performing the settings of slot
The SLOT INFO submenu allows you to confirm the
boards inserted into various slots and make settings for
those boards.
Design of the SLOT INFO submenu
1 SLOT number
1 SLOT number
Displays and selects the slot number.
2 Board
Displays and selects the board. Depending on the type
of board currently selected, you can display and select
all sorts of settings.
2 Board