Mazda CX-9 Grand Touring 2007 Manual page 336

10.7-24.5 N.m {1.1-2.4 kgf.m, 7.9-18.0 ft.lbf}
14. Install the fan control module No.2 (Dual fan control module) (see FAN MOTOR
REMOVAL/INSTALLATION [MZI-3.5] .)
15. Connect the negative battery cable.
16. Start the engine and confirm that there is no oil leakage.
If there is oil leakage, repair or replace the applicable part.
17. Install the engine cover.
Fig. 4: Applying Silicone Sealant To Oil Pressure Switch Threads
Courtesy of MAZDA MOTORS CORP.
OIL FILTER REPLACEMENT [MZI-3.5]
WARNING:
CAUTION:
1. Remove the oil filter using a oil filter wrench.
2. Use a clean rag to wipe off the mounting surface on the oil filter adapter and the oil filter.
3. Apply clean engine oil to the O-ring of a new oil filter.
4. Install the oil filter until the O-ring contacts the sealing surface.
5. Tighten the oil filter 3/4 turns by hand.
2007 Mazda CX-9 Grand Touring
2007 ENGINE Lubrication (MZI-3.5) - CX-9
Hot engines and engine oil can cause severe burns. Turn off the
engine and wait until it and the engine oil have cooled.
A vehicle that is lifted but not securely supported on safety stands is
dangerous. It can slip or fall, causing death or serious injury. Never
work around or under a lifted vehicle if it is not securely supported
on safety stands.
Continuous exposure to USED engine oil has caused skin cancer in
laboratory mice. Protect your skin by washing with soap and water
immediately after working with engine oil.
If engine oil is spilled on the exhaust system, wipe it off completely. If
you fail to wipe the spilled engine oil, it will produce fumes because
of the heat.