Mazda CX-9 Grand Touring 2007 Manual page 642

2007 ENGINE PERFORMANCE On-Board Diagnostic (MZI-3.5) - CX-9
stored DTCs.
Is other DTCs present?
4 INSPECT FOR CORRECT PCM
OPERATION
Disconnect all the PCM
connectors.
Visually inspect for:
Pushed out pins
Corrosion
Connect all the PCM connectors
and verify that they seat correctly.
Retrieve DTCs using the M-MDS.
Is the PENDING CODE for this
DTC present?
5 VERIFY TROUBLESHOOTING OF
DTC P061B HAS BEEN
COMPLETED
Verify that all disconnected
connectors are reconnected.
Turn the ignition switch to the ON
position (Engine off).
Clear the DTC from the PCM
memory using the M-MDS.
Perform the "KOEO and KOER
self-test".
(See KOEO/KOER SELF TEST
[MZI-3.5].)
Retrieve DTCs using the M-MDS.
Is the PENDING CODE for this
DTC present?
6 VERIFY AFTER REPAIR
PROCEDURE.
Perform the "AFTER REPAIR
PROCEDURE".
(See AFTER REPAIR
PROCEDURE [MZI-3.5].)
2007 Mazda CX-9 Grand Touring
No
Yes
No
Yes
No
Yes
No
Go to the next step.
Replace the PCM, then go to the next step.
(see PCM
REMOVAL/INSTALLATION [MZI-
3.5] .)
Go to the next step.
Replace the PCM, then go to the next step.
(see PCM
REMOVAL/INSTALLATION [MZI-
3.5] .)
Go to the next step.
Go to the applicable DTC inspection.
(See DTC TABLE [MZI-3.5].)
Troubleshooting completed.