Mazda CX-9 Grand Touring 2007 Manual page 257

NOTE:
Lubricate the rear oil seal lips and bore with clean engine oil.
1. Push the rear oil seal slightly in by hand.
2. Tap the rear oil seal in evenly using the SST and a hammer.
Substitution SST
49 W011 101
Outer diameter: 105 mm {4.13 in} or more Inner diameter: 93-105 mm {3.7-4.1 in} Tube with
board thickness 2 mm {0.079 in} or more
Fig. 105: Tapping In Rear Oil Seal Using SST
Courtesy of MAZDA MOTORS CORP.
ENGINE REMOVAL/INSTALLATION [MZI-3.5]
WARNING:
1. Perform "Fuel Line Safety Procedures". Leave the fuel pump relay removed. (see BEFORE REPAIR
PROCEDURE [MZI-3.5] .)
2. Disconnect both battery cables.
3. Remove the battery and battery tray. (see BATTERY REMOVAL/INSTALLATION [MZI-3.5] .)
4. Drain the power steering fluid. (see POWER STEERING FLUID INSPECTION .)
5. Drain the engine coolant. (see ENGINE COOLANT REPLACEMENT [MZI-3.5] .)
6. Remove the engine cover. (See ENGINE COVER REMOVAL/INSTALLATION [MZI-3.5].)
7. Remove the ventilation hose. (see QUICK RELEASE CONNECTOR (EMISSION SYSTEM)
2007 Mazda CX-9 Grand Touring
2007 ENGINE Mechanical (MZI-3.5) - CX-9
Fuel vapor is hazardous. It can very easily ignite, causing serious
injury and damage. Always keep sparks and flames away from fuel.
Fuel line spills and leakage are dangerous. Fuel can ignite and cause
serious injuries or death and damage. Fuel can also irritate skin and
eyes. To prevent this, always complete the "Fuel Line Safety
Procedure". (see BEFORE REPAIR PROCEDURE [MZI-3.5] .)