Mazda CX-9 Grand Touring 2007 Manual page 684

2007 ENGINE PERFORMANCE On-Board Diagnostic (MZI-3.5) - CX-9
Has FREEZE FRAME DATA
been recorded?
2 VERIFY RELATED REPAIR
INFORMATION AVAILABILITY
Verify related Service Bulletins
and/or on-line repair information
availability.
Is any related Service Bulletins
available?
3 VERIFY RELATED PENDING
CODE OR STORED DTCs
Turn the ignition switch off then
to the ON position (Engine off).
Verify related pending code or
stored DTCs.
Are other DTCs present?
4 INSPECT FOR CORRECT PCM
OPERATION
Disconnect all the PCM
connectors.
Visually inspect for:
Pushed out pins
Corrosion
Connect all the PCM connectors
and verify that they seat correctly.
Retrieve DTCs using the M-MDS.
Is the PENDING CODE for this
DTC present?
5 VERIFY TROUBLESHOOTING OF
DTC P1001 HAS BEEN
COMPLETED
Verify that all disconnected
connectors are reconnected.
Turn the ignition switch to the ON
position (Engine off).
Clear the DTC from the PCM
memory using the M-MDS.
Start the engine and run it at idle.
2007 Mazda CX-9 Grand Touring
No
Yes
No
Yes
No
Yes
No
Yes
Record FREEZE FRAME DATA on the
repair order, then go to the next step.
Perform repair or diagnosis according to
the available Service Bulletins.
If the vehicle is not repaired, go to
the next step.
Go to the next step.
Go to the appropriate DTC
troubleshooting.
(See DTC TABLE [MZI-3.5].)
Go to the next step.
Replace the PCM, then go to the next step.
(see PCM
REMOVAL/INSTALLATION [MZI-
3.5] .)
Go to the next step.
Replace the PCM, then go to the next step.
(see PCM
REMOVAL/INSTALLATION [MZI-
3.5] .)