Mazda CX-9 Grand Touring 2007 Manual page 641

2007 ENGINE PERFORMANCE On-Board Diagnostic (MZI-3.5) - CX-9
Perform the "After Repair
Procedure".
(See AFTER REPAIR
PROCEDURE [MZI-3.5].)
Are any DTCs present?
DTC P061B [MZI-3.5]
DTC P061B (MZI-3.5) DETECTION CONDITION AND POSSIBLE CAUSES
DTC P061B Internal control module torque calculation performance
DETECTION
CONDITION
POSSIBLE CAUSE
DIAGNOSTIC PROCEDURE
DTC P061B (MZI-3.5) DIAGNOSTIC PROCEDURE
STEP
1 VERIFY FREEZE FRAME DATA
HAS BEEN RECORDED
Has FREEZE FRAME DATA
been recorded?
2 VERIFY RELATED REPAIR
INFORMATION AVAILABILITY
Verify related Service Bulletins
and/or on-line repair information
availability.
Is any related Service Bulletins
available?
3 VERIFY RELATED PENDING
CODE OR STORED DTCs
Turn the ignition switch off then
to the ON position (Engine off).
Verify related pending code or
2007 Mazda CX-9 Grand Touring
Indicates that a calculation error occurred in the PCM.
Connector or terminal malfunction
NOTE:
This DTC is an informational DTC and may be set in combination
with a number of other DTCs which are causing the FMEM.
Diagnose other DTCs first.
INSPECTION
No Troubleshooting completed.
ACTION
Yes Go to the next step.
No Record FREEZE FRAME DATA on the
repair order, then go to the next step.
Yes Perform repair or diagnosis according to
the available Service Bulletins.
If the vehicle is not repaired, go to
the next step.
No Go to the next step.
Yes Go to the appropriate DTC
troubleshooting.
(See DTC TABLE [MZI-3.5].)