Mazda CX-9 Grand Touring 2007 Manual page 637

2007 ENGINE PERFORMANCE On-Board Diagnostic (MZI-3.5) - CX-9
Disconnect all the PCM
connectors.
Visually inspect for:
Pushed out pins
Corrosion
Connect all the PCM connectors
and verify that they seat correctly.
Retrieve DTCs using the M-MDS.
Is the PENDING CODE for this
DTC present?
5 VERIFY TROUBLESHOOTING OF
MISFIRE DTC P060A, P060C AND
P061D HAS BEEN COMPLETED
Verify that all disconnected
connectors reconnected.
Turn the ignition switch to the ON
position (Engine off).
Clear the DTC from the PCM
memory using the M-MDS.
Perform the "KOEO and KOER
self-test".
(See KOEO/KOER SELF TEST
[MZI-3.5].)
Retrieve DTCs using the M-MDS.
Is the PENDING CODE for this
DTC present?
6 VERIFY AFTER REPAIR
PROCEDURE
Perform the "AFTER REPAIR
PROCEDURE".
(See AFTER REPAIR
PROCEDURE [MZI-3.5].)
Are any DTCs present?
DTC P060B [MZI-3.5]
DTC P060B (MZI-3.5) DETECTION CONDITION AND POSSIBLE CAUSES
2007 Mazda CX-9 Grand Touring
No
Yes
No
Yes
No
3.5] .)
Go to the next step.
Replace the PCM, then go to the next step.
(see PCM
REMOVAL/INSTALLATION [MZI-
3.5] .)
Go to the next step.
Go to the applicable DTC inspection.
(See DTC TABLE [MZI-3.5].)
Troubleshooting completed.