Mazda CX-9 Grand Touring 2007 Manual page 255

1. Rotate the crankshaft clockwise, and set a wrench to the drive plate bolt at the position shown in the
figure to lock the crankshaft rotation.
2. Tighten the new crankshaft pulley lock bolt in 4 steps.
1. Tighten to 120 N.m {12.2 kgf.m, 88.5 ft.lbf}.
2. Loosen 360° (one full turn) in reverse order.
3. Tighten to 47-53 N.m {4.8-5.4 kgf.m, 35-39 ft.lbf}.
4. Tighten 85°-95°.
3. Verify the tightening torque for the drive plate installation bolt to which the wrench has been set. (see
COOLANT RESERVE TANK REMOVAL/INSTALLATION [MZI-3.5] .)
Fig. 101: Identifying Drive Plate Bolt
Courtesy of MAZDA MOTORS CORP.
4. Install the cover as shown in the figure.
Fig. 102: Identifying Cover With Fasteners
Courtesy of MAZDA MOTORS CORP.
REAR OIL SEAL REPLACEMENT [MZI-3.5]
2007 Mazda CX-9 Grand Touring
2007 ENGINE Mechanical (MZI-3.5) - CX-9