Mazda CX-9 Grand Touring 2007 Manual page 682

2007 ENGINE PERFORMANCE On-Board Diagnostic (MZI-3.5) - CX-9
DETECTION
CONDITION
POSSIBLE CAUSE
DIAGNOSTIC PROCEDURE
DTC P1000 (MZI-3.5) DIAGNOSTIC PROCEDURE
STEP
1 VERIFY FREEZE FRAME DATA
HAS BEEN RECORDED
Has FREEZE FRAME DATA been
recorded?
2 VERIFY RELATED REPAIR
INFORMATION AVAILABILITY
Verify related Service Bulletins
and/or on-line repair information
availability.
Is any related Service Bulletins
available?
3 DTC P1000: INSPECT FOR OTHER
DTCS
This test should be used only if
DTC P1000 was received in
Continuous Memory. Ignore any
DTC P1000s in KOEO or KOER.
NOTE:
Were any other DTCs received with
P1000?
4 REQUEST TO CLEAR DTC P1000
2007 Mazda CX-9 Grand Touring
P1000 indicates that the OBD-II monitor testing is not complete.
The vehicle is new from the factory and has not yet completed an OBD-II
Drive Cycle.
The battery or the PCM has been disconnected.
OBD-II monitor malfunction had occurred before completion of an OBD-II
Drive Cycle.
The PCM DTCs have been cleared with an M-MDS tester as part of a
service process.
INSPECTION
DTC P1000 indicates that all
of the OBD-II monitors have
not yet been successfully
tested to clear DTC P1000.
ACTION
Yes Go to the next step.
No Record FREEZE FRAME DATA on the
repair order, then go to the next step.
Yes Perform repair or diagnosis according to
the available Service Bulletins.
If the vehicle is not repaired, go to
the next step.
No Go to the next step.
Yes Repair other DTCs. Go to the applicable
DTC Troubleshooting.
No Go to the next step.
Yes Perform the Drive Mode.