Configuring The Boot Drive; Removing A Hard Drive From A Hard-Drive Carrier; Installing A Hard Drive In A Drive Carrier - Dell PowerEdge M605 Hardware Owner's Manual

See your operating system documentation for more information on taking
the hard drive offline.
2 Open the hard-drive carrier handle to release the drive. See Figure 3-24.
3 Slide the hard drive out until it is free of the drive bay.
If you are permanently removing the hard drive, install a blank insert.
Shutdown Procedure for Servicing a Hard Drive
NOTE:
This section applies only to situations where the blade must be powered
down to service a hard drive. In many situations, the hard drive can be serviced
while the blade is powered on.
If you need to power off the blade to service a hard drive, wait 30 seconds
after the blade's power indicator turns off before removing the hard drive.
Otherwise, the hard drive may not be recognized after the hard drive is
reinstalled and the blade is powered on again.

Configuring the Boot Drive

The drive or device from which the system boots is determined by the boot
order specified in the System Setup program (see "Using the System Setup
Program" on page 79.

Removing a Hard Drive From a Hard-Drive Carrier

Remove the four screws from the slide rails on the hard-drive carrier and
separate the hard drive from the carrier. See Figure 3-24.

Installing a Hard Drive In a Drive Carrier

1 Insert the hard drive into the hard-drive carrier with the connector end
of the drive at the back of the carrier. See Figure 3-24.
2 Align the screw holes on the hard drive with the holes on the hard-drive
carrier.
3 Attach the four screws to secure the hard drive to the hard-drive carrier.
144
Installing Blade Components