System Messages - Dell PowerEdge M605 Hardware Owner's Manual

Table 1-17. Ethernet Pass-through Module Indicators
Indicator Type
Link
indicator/activity
indicator
Power indicator
Status/
identification
indicator
NOTE:
Ethernet media speed is configured through the blade LOM firmware or by the
operating system. Speed and duplex settings are not configured through the pass-
through module itself.

System Messages

Table 1-18 lists the system messages that can occur and the probable cause
and corrective action for each message.
CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
NOTE:
If you receive a system message that is not listed in Table 1-18, check the
documentation for the application that is running when the message appears, or the
operating system's documentation for an explanation of the message and
recommended action.
66
About Your System
Pattern Description
Green on, The Ethernet connector is linked to the blade and
amber there is network activity.
blinking
Green on, The Ethernet connector is linked to the blade and
amber off there is no network activity.
Green off, The Ethernet connector is not linked to the blade
amber and there is network activity.
blinking
Green The Ethernet connector is not linked to the blade
off/amber off and there is no network activity.
Off Power to the module is off.
Green Module has power.
Blue on Active module.
Amber Fault condition in module.
flashing
Many repairs may only be done by a certified service technician. You